1 thought on “What is the tutorial of the necklace tie rope hanging pendant tutorial?”
Shelly
Preparation tools: Put a perforated jade, pendant rope, a scissors, and a lighter. 1. Use the lighter point version of the roasted pendant to penetrate the ends of the hole right rope, and quickly twist it into brushed (pictured), and then cut off the excess part of the rope with scissors. 2. Pass the two pendants from the back of the pendant (pictured), and reserve the distance between the pendant hole and the knot of about 1 cm (the length can be reserved according to the actual needs). 3. Put the No. 1 rope in the figure on the two front -end ropes. The No. 2 rope is sent by bypassed the No. 1 rope from the top. 4. After completing the piercing method as shown in Figure 4, tighten the two ropes (as shown in Figure 4). 5. Put the No. 1 rope on the top of the two front -end ropes. The No. 2 rope is bypassed above the No. 1 rope, then the two front -end ropes are bypassing the two front -end ropes, and passing through the rope ring (Figure picture 5. Figure 6). 6, as shown in the figure. 7, after completing step 6, tighten the two ropes of the pendant to get the passing of the pendant rope shown in Figure 7. 8, repeat 1-7 steps 3 times to get the passage shown in Figure 8, the knotting method here can also increase the number of repetitions according to your needs. 9. Cut off the excess rope with scissors, then burn the rope port with a lighter, and press the flat rope port. At this point, the pendant rope was completed.
Preparation tools: Put a perforated jade, pendant rope, a scissors, and a lighter.
1. Use the lighter point version of the roasted pendant to penetrate the ends of the hole right rope, and quickly twist it into brushed (pictured), and then cut off the excess part of the rope with scissors.
2. Pass the two pendants from the back of the pendant (pictured), and reserve the distance between the pendant hole and the knot of about 1 cm (the length can be reserved according to the actual needs).
3. Put the No. 1 rope in the figure on the two front -end ropes. The No. 2 rope is sent by bypassed the No. 1 rope from the top.
4. After completing the piercing method as shown in Figure 4, tighten the two ropes (as shown in Figure 4).
5. Put the No. 1 rope on the top of the two front -end ropes. The No. 2 rope is bypassed above the No. 1 rope, then the two front -end ropes are bypassing the two front -end ropes, and passing through the rope ring (Figure picture 5. Figure 6).
6, as shown in the figure.
7, after completing step 6, tighten the two ropes of the pendant to get the passing of the pendant rope shown in Figure 7.
8, repeat 1-7 steps 3 times to get the passage shown in Figure 8, the knotting method here can also increase the number of repetitions according to your needs.
9. Cut off the excess rope with scissors, then burn the rope port with a lighter, and press the flat rope port. At this point, the pendant rope was completed.